Can you cut pavers with a tile saw

So, can you cut pavers with a tile saw? Yes, if your current blade is labeled for the material your pavers are made out of. If not, a trip to the hardware store is in order to ensure you have the proper blade to cut your pavers using your tile saw.

It will almost certainly wear out your blade faster, could cause enough friction to melt the metal bond over the diamond particles, or could wear down the diamonds faster than it cuts through the bond. However, there is a chance that your cuts will chip and crack, or that an overheated blade could become a safety hazard.

Then it comes to the issue of fence adjustment straight to the marked line of the paver you are cutting so that you can get immaculate cut. Just make sure that the fence is parallel to the drawn line and the blade is on or over the line so that no devious and inappropriate cuts come. Never forget to turn your wet saw off when you do the fence alignment and after every cut. At the time of cutting both small and big sized pavers, sometimes it gets troublesome to handle the paver you are cutting.

Always be careful that your hands are not coming too close to the moving blade. Try to keep enough space in the pavers after marking so that you can press and keep the pavers static on the table or floor. But if there is very narrow space in the paver to hold and move, use any plastic or wooden or metal stick instead of your hand to push the paver into the running blade.

Some manufacturers make it quite easy for you by attaching a tray for the cutting material. In this case, you can just push forward the tray to cut the paver. You may need to have many diversified cuts with different size and shape as per your floor plan. Your wet saw is an expert to get you many diverse cuts such as bevel cut, diagonal cut, partial cut, complex cut, straight cut, notch cut and so on. To get straight cut you just keep the blade on the marked line of the paver and start your saw and then slowly push the paver into the blade.

Then remove the cutted parts with tile snipers to get your desired notch. Bevel cut is made on the edge of the paver for decorative purpose to make transition to another paver or floor when there is large gap between the pavers.

To make diagonal cut put the blade on the drawn line and align the fence with the blade, then slowly push forward the paver to cut. For electrical wiring or any other obstacle you may need partial cut such as L- shaped cut on your pavers which you can get by cutting it until it reaches to the desired depth. Crystalline Silica. National Cancer Institute. Actively scan device characteristics for identification. Use precise geolocation data.

Select personalised content. Create a personalised content profile. Measure ad performance. Select basic ads. Create a personalised ads profile. Select personalised ads. Apply market research to generate audience insights. Measure content performance. Develop and improve products. List of Partners vendors. Project Overview. Warning Always wear a dust mask and goggles when cutting any type of paver.

Featured Video. Materials Patio pavers. How to Design and Install a Paver Patio. Article Sources. The Spruce uses only high-quality sources, including peer-reviewed studies, to support the facts within our articles.

Read our editorial process to learn more about how we fact-check and keep our content accurate, reliable, and trustworthy. Show Full Article. Your Privacy Rights.